A copper plated cathodic ground rod for attracting free moisture molecules in electro-osmotic damp proof sytems

Commercially pure titanium crimps for connecting titanium wires when using an electro osmosis system for damp proofing stone walls with rubble fill. Pack quantity 10.

ISO-THERM is an ultra thin specially woven polyester based thermal wall insulation , it is flexible and lightweight and will accommodate a plaster skim finish.

Heat recovery fans control humidity levels and reduce the likelihood of condensation. This heat exchange ventilation unit provides a continuous air change with minimum heat loss

Fixings for securing insulated plasterboard sheets to brick and block walls. Fire proof fasteners with galvanized coating for internal solid wall insulation in packs of 20 or boxes of 400

Heat recovery units in a multi-buy pack of 4. These humidity control heat exchange fans reduce relative humidity and alleviate condensation, providing continuous ventilation with minimum heat loss.

Easy to operate, the Flood Pump Kit will remove flood water from your property with speed and efficiency. Fully automatic submersible pump, long (20m) discharge hose and filtered tank. Discharges up to 10,000 litres/ hour

A waterproof fibre faced sealing tape for butt joining mesh-faced damp proofing membrane. The fibre tape takes traditional renders and dot and dab adhesives. 25m x 115mm

Water-guard drainage channels drains groundwater from basements. Each 2 m long conduit has perforated sides and an upstand. Available in single pieces or a box of 8 pieces.

Hammer-in fixing with waterproof seal for use with air gap mesh membranes. Roughened head provides a key for plaster finishes. Bag quantity: 200

Mesh-faced membrane with 3mm studs and a polypropylene mesh to provide a key for plaster, render or plasterboard dry lining on plaster dabs. Roll sizes: 10m2, 20m2 and 40m2

CM8-Mesh Membrane withf 8mm studs and polypropylene mesh key for direct application of plaster, render or adhesive dabs for plasterboard dry lining. Rolls sizes: 20m2 and 40m2

Hammer-in fixing for use with Baseline Mesh waterproofing membrane. Keyed surface to receive direct application of wall plaster or plasterboard on adhesive dabs. - Box Quantity: 200

Helical twist nails fix timber battens to masonry. The fixing corkscrews through timber and self-taps into masonry to deliver a cost effective method of battening out for dry-lining - Packs of 100 with FREE SDS tool

Hammer-in fixing with waterproof seal for use with Baseline 8 & Thermseal waterproofing membranes. Screw wall studs directly into aperture located in plug head. Quantity: Box of 200

Metal insulation fixings for anchoring Rockwool & Knauff fireproof insulation panels to masonry walls & concrete soffits. Corrosion resistant Stainless Steel Rendalath fixing - Pack sizes 20 & 400

Helical warm roof nails in galvanised steel. For fixing Kingspan 6mm ply-faced insulation boards to joists or rafters. Hammer in fixings for flat warm roof applications with boards 40-185mm deep - 20 Bag or 400 Box

Insulation fasteners for fixing ply-faced Celotex or Kingspan decking boards. Hammer in fixings for flat warm roof deck insulation upto 210mm deep. Rust resistant Stainless Steel - 20 Pk or 400 Box

Superior warm roof nails for fixing Kingspan or Celotex insulation between counter-batten & rafter. Powerful Super-7 fixings reduce warm roofing costs by virtue of less nailing – Pack Quantity 50

Zinc plated insulation fixing for anchoring mineral wool and rigid insulation panels to masonry walls & concrete soffits. Galvanised Rendalath fixing - Pack sizes 20 bags & 400 boxes

Mechanical insulation anchor with plastic plug and glass filled nylon drive pin for fixing Kingspan & Celotex wall insulation. Use with load spreading washer for fixing mineral wool. Sizes: 70 - 180mm Long. Box Qty: 250

A flexible waterproofing rope for for sealing brick and plaster plugs when fixing waterproof tanking membrane systems to walls. Can be used as a tape. 5m x 10mm

This 2-part brick tie services the basement waterproofing industry. The fastener arrangement comprises a polypropylene plug fitted with a seal, and a stainless steel helical tie. Quantity: 50

Thin joint ties for use with Thermalite, Durox and Celcon Aircrete blockwork. Used in cavity construction to tie Aircrete masonry to brick facades. - Pack Quantity 50