Easy to operate, the Flood Pump Kit will remove flood water from your property with speed and efficiency. Fully automatic submersible pump, long (20m) discharge hose and filtered tank. Discharges up to 10,000 litres/ hour

General-purpose, quick drying damp proof paint that dries to form a water-proof membrane. An effective penetrating damp treatment for waterproofing wall surfaces. 5L

Dry Seal masonry water repellent is a high strength silane cream treatment that waterproofs brick and stone facades including walls, bridges and tunnels. 3kg Tub

No More Damp EP40 floor coating system is a water based two part system consisting of an Epoxy Primer and a Epoxy Finish coat in Grey or Clear. Sold in 5 kg containers.

A waterproof fibre faced sealing tape for butt joining mesh-faced damp proofing membrane. The fibre tape takes traditional renders and dot and dab adhesives. 25m x 115mm

A lightweight renovating plaster pre-mix with perlite, fibres & water repellent additives. For use following damp proof treatments or in conjunction with cementitious tanking coatings. 20KG

Water-guard drainage channels drains groundwater from basements. Each 2 m long conduit has perforated sides and an upstand. Available in single pieces or a box of 8 pieces.

Hammer-in fixing with waterproof seal for use with air gap mesh membranes. Roughened head provides a key for plaster finishes. Bag quantity: 200

Water repellent surface treatment for wall suffering from penetrating damp. Prevents moisture migrating through masonry walls and brickwork facades. Costs much less than weather resistant render products. 5 Litres

Mesh-faced membrane with 3mm studs and a polypropylene mesh to provide a key for plaster, render or plasterboard dry lining on plaster dabs. Roll sizes: 10m2, 20m2 and 40m2

CM8-Mesh Membrane withf 8mm studs and polypropylene mesh key for direct application of plaster, render or adhesive dabs for plasterboard dry lining. Rolls sizes: 20m2 and 40m2

Hammer-in fixing with waterproof seal for use with Baseline 8 & Thermseal waterproofing membranes. Screw wall studs directly into aperture located in plug head. Quantity: Box of 200

A flexible waterproofing rope for for sealing brick and plaster plugs when fixing waterproof tanking membrane systems to walls. Can be used as a tape. 5m x 10mm

This 2-part brick tie services the basement waterproofing industry. The fastener arrangement comprises a polypropylene plug fitted with a seal, and a stainless steel helical tie. Quantity: 50

Hammer-in fixing for use with Baseline Mesh waterproofing membrane. Keyed surface to receive direct application of wall plaster or plasterboard on adhesive dabs. - Box Quantity: 200

A high quality waterproofing tape that is applied to the lap joints of abutting cavity-drain membranes. This flexible butyl rubber tape forms a water-tight joint seal. 22.5m x 28mm

A wide flexible membrane tape for sealing and waterproofing the wall-floor junction of cavity drain membrane systems. This 150mm wide waterproofing tape is available in 20m rolls

A single sided overseal tape used to seal over the top of lapping membranes. It serves as a vapour barrier and a waterproof seal on externally taped joints 22.5m x 75mm

Hydraplug waterproofing putty is a quick setting cementitious compound. It is mixed with water and applied as a putty to plug and stop active water leaks. 5kg

Basement membrane for tanking walls and floors in basement waterproofing schemes. Cavity drain membranes are available in 40m2 and 48m2 rolls for cost effective basement waterproofing. Multi-Pack: 6 rolls. Sizings: 2 x 20m or 2 x 2.4m.

Wykamol CM 20 mm Hi-Viz cavity drain membrane for waterproofing basement floors. 40 sqm high-visibility yellow tanking membranes are in stock and sold in at trade prices. 2 x 20 m.

CM8 is a versatile 8mm high tanking membrane for use in waterproofing damp proofing applications above and below ground level. Options: Rolls of 40m2 and 48m2

Waterproofing membrane kit with everything needed for waterproofing. Sizings 2 x 20m or 2 x 2.4m of floor or wall. Fix studs to basement membrane plugs for dry-lining walls. Lay screed direct.

Mesh membrane kit in 3 sizes with everything needed for waterproofing wall surfaces. These waterproof tanking membranes include a mesh face for direct application of plaster or dabs for plasterboard. 2.20m or 2.10m sizings